Please note this is not a window cling or printed decal.
It does not have a background, which means the decal will require a different installation process.
Temperatures affect the decal. Do not apply in direct sunlight or when the surface is too hot, as decal may bubble.
If this occurs simply use a pin and puncture the bubble.
Min application temperature above 46 degrees F is required.
If the decal does not release from the backing paper, gently buff the decal until it adheres to the transfer tape. Temperature changes can cause this issue.
Once the decal touches the mounting surface it can’t be removed.
STEP 1 Prepare the decal for application by firmly rubbing a squeegee or credit card across the clear transfer tape. This removes any air bubbles that may have formed and makes the decal cling to the transfer tape.
STEP 2 Clean the area with rubbing alcohol or soap and water. *** Do not use Windex. *** Allow area to dry before application. Place the decal in the desired location with a piece of masking tape on the top of the decal to hold it in place.
STEP 3 Slowly peel off the backing layer from the decal. Only the vinyl and the clear transfer tape should remain.
STEP 4 Slowly lower the decal and rub it in place with a squeegee or credit card. Start at the top middle and then the outer edges. Firmly rub the sticker in place to make sure there is no air trapped under the decal. If this occurs simply use a pin and puncture the bubble.
STEP 5 Slowly peel the clear transfer tape off at an angle. Be careful not to pull the decal off the surface. If the decal pulls away from the surface repeat step 4. ONLY the vinyl decal should remain.
Things to know before you apply your decal
Temperature effects the decal. Do NOT apply in direct sunlight or when surface is hot, as decal may bubble. If this occurs simply use a pin and puncture the bubble.
Minimum application temperature above 460 F. is required.
If the decal does NOT release from the backing paper, gently buff the decal until it adheres to the transfer tape. Temperature changes can cause this issue.
Use of products containing waxes, Rain-X or other silicone polymer additives will prevent your decal from sticking.
Once the decal touches the mounting surface it cannot be removed!
Some electronics such as phones and computers are coated with nano particles to prevent figure prints. Your decal may NOT adhere to these surfaces.
If you have any questions or concerns, please contact our customer service.